ISOKINETIK CARDAS TONEARM CABLE STRAIGHT 5 PIN CARDAS SDIN E
0 Item Items
This product is no longer in stock
Warning: Last items in stock!
ISOKINETIK CARDAS STRAIGHT TONEARM CABLE
1.2m long CARDAS 4 X 23 AWG LITZ SHEILDED
CARDAS SDIN E STRAIGHT 5 PIN TONEARM CONNECTOR AND 2 x HIGH QUALITY RHODIUM OVER SILVER PLATING CARDAS GRCM RCA PLUGS
Small RCA male, non- magnetic, eutectic Brass, Rhodium over Silver plate. 6mm cable opening, Brass cover, Gold plate.
The GRCM is used on Cardas Microtwin and Crosslink interconnects.
The GRCM is a variant of our GRCM 6, with a 7.5mm cable opening (the GRCM 6 has a 6 mm cable opening).
CARDAS 2 x 24 AWG LITZ 4 CORE CARDAS LITZ 4 x 24 AWG LITZ SHIELDED CABLE FOR
THE CABLE HAS 2 cores for left channel and 2 cores for right channel and is shielded
The conductors are Cardas high quality ultra pure copper Litz each individual strand insulated with enamel teh overal conductor uses PTFE as the dielectric the condcutors are then twisted together this is to cancel EMI and minimize crosstalk, then insulated again with PTFE and shield.
Cardas Golden Section Tonearm Litz designed specifically for wiring and rewireing the worlds best tonearms.
Like many products, Cardas Fine wire developed out of a need that could not be filled. The availability of ultra pure, ultra soft conductor strand had decreased to the point of unavailability in this country in the mid eighties, due part to the development of and evolution of mass production techniques such as resistance annealing and mandatory recycling. Industrial copper was cheap and plentiful. However, super pure and ultra soft copper became unobtainable . The general condition of available copper became so bad that manufacturers began going off shore for product. Still, the consistency of product was poor and costs soon became astronomical, and we were forced to make our own.
We found that care and consistency at every step of the drawing process and a bunch of nines after the decimal point were not enough. It made little sense to start with pure copper/silver just to have it harden and oxidize during the drawing process and after manufacture. Instead we developed a process where the copper is actually purified and super annealed during the drawing process and developed a coating process to protect the copper between steps and after production.
At first our only customer we had was ourselves, and our livelihood depended on the perfection and purity of our metals. We are still our own best critic, we still make the most perfect product we know of, and absolutely do things the best way possible. We start with the best available copper on the market, ultra pure bar with 0 recycling content. We then, using our own proprietary process, draw and anneal the metal in a reduction atmosphere.
Unlike conventional coppers that are quick annealed with an electric current process called "resistance annealing", our coppers are annealed the hard way, in hydrogen reduction ovens. Not just at the end of the drawing process, but at every step in the process in the ultra grades (Grade 1), and every other step in the super(Grade 2) .
Custom diamond dies polish the wire as it is drawn, not just at the final step, but at every step in the process.
At Cardas we use urethane enameled conductor for the construction of our cables. This is a very permanent protective process.
No customer comments for the moment.